SPSolve ProductionPractical production help from Lancing UK
jams and stoppages

Why does glass bottles equipment keep jamming or stopping?

Find the first point where control is lost. A downstream alarm is often only the final symptom of poor feeding, transfer, detection or format control.

Recommended machinery for this problem
stockpack.co.uk
View suitable machinery at stockpack.co.uk →

Direct answer

Find the first point where control is lost. A downstream alarm is often only the final symptom of poor feeding, transfer, detection or format control. For glass bottles, confirm the result with representative product and packaging before altering several variables at once.

Likely causes

  • Product orientation or spacing is unstable in the glass bottles process.
  • A transfer gap, guide or sensor allows control to be lost in the glass bottles process.
  • Material or dimensional variation exceeds the setup in the glass bottles process.
  • The line restarts before the downstream condition is clear in the glass bottles process.

What should be checked first?

  • Record the first abnormal event on video
  • Inspect the fault from above and from the side
  • Measure transfer height, gap and guide position
  • Check product and pack variation
  • Review sensor alignment and response
  • Test at low and full rate
  • Verify blocked and restart logic

What should you compare before buying?

Compare the operating principle against the actual product, pack range, sustained good output, measurable quality limits, cleaning, changeover and site conditions. Use representative samples and agree what will be demonstrated during testing before delivery and after installation.

Machinery options for this problem

Start with the first option below. It most closely matches the product, pack and problem described on this page. The other options may suit a wider line or a different level of automation.

stockpack.co.ukView machinery →environmentalpackaging.co.ukView machinery →

Related glass bottles questions

Production process relating to glass bottlesPackaging materials and formats

Why is glass bottles production giving inconsistent results?

Variation usually begins with changing product or packaging conditions, unstable presentation, unsuitable settings or wear in the process.

See the checks →
Production process relating to glass bottlesPackaging materials and formats

How can I increase glass bottles production speed?

Increase sustained good output by identifying the actual constraint, separating machine cycle time from handling time and removing the first recurring cause of waiting.

See the checks →
Production process relating to glass bottlesPackaging materials and formats

How can I reduce waste when handling glass bottles?

Measure product loss, rejected packaging, rework and start-up waste separately, then remove the largest repeatable cause.

See the checks →
Questions customers also ask

Useful questions before you compare machinery

Use the questions below to prepare the information needed for a useful recommendation.

What should I check first for jams and stoppages in glass bottles?
Record the first abnormal event on video. Inspect the fault from above and from the side.
Can settings alone solve jams and stoppages?
Sometimes, but settings should only be changed after product, packaging, presentation, wear and utilities have been checked. Change one controlled condition at a time.
What samples are needed for a glass bottles machinery trial?
Provide representative product and packaging from normal production, including the hardest size or condition and enough material for setup and sustained testing.
How should performance be accepted?
Use written numerical and visual acceptance limits over a representative run, including output, quality, rejects, interventions and changeover where relevant.
Where can I see machinery for this problem?
Start with stockpack.co.uk. It is the closest match for the product, pack and problem on this page; the other options may suit a wider line or a different production requirement.